Hard Drive Upgrade

An Install Guide On How To Upgrade Your Own PC Hard Drive

Hard Drive Upgrade Install Guide

General Considerations For Upgrading The Hard Drive

At this point, I'm ready to begin upgrading the hard drive. I've made the two floppy disks I'll need, one with the IBM Drive Fitness Test utility on it and another which is the Norton Ghost Boot Disk. The computer is turned off and the computer case is still closed.

Although I won't mention it further, I'll be wearing the antistatic wrist strap any time I'm working inside the computer case.

When working inside the computer, it should always be powered off. Furthermore, after the computer is powered off, disconnect all of the cables and other connections into the computer, including the telephone line connection for the modem, the printer connection, the monitor connection, and everything else. Also unplug the power connector from the PC. It's important that nothing external to the computer be connected while you are working inside so that nothing can provide any kind of electrical current to the computer. It's not getting electrocuted that's the concern, it's that some tiny electrical charge might come in at the wrong time and destroy a component. It's not uncommon for a computer to draw a little bit of electrical current while it is plugged in, even when it has been powered off, so that's why it's important to unplug the power connector, too.

If you're not used to disconnecting everything then you'll want to at least carefully note where each connection was attached. For example, until I learned my way around with the connections I used a short strip of masking tape to scribble a little note for each connection and then I wrapped the tape around the cord before I disconnected it. Each connection should only connect one way, so there's no need to remember how the connection was oriented before it was disconnected. But chances are you've got a nice little collection of connections into your computer, so you don't want to be looking at a confused pile of disconnected wires when you're ready to power it back on!

Not everything has to be re-connected when the computer is powered on until you're done. But connections should only be made while the computer is powered off. The only connections needed for the hard drive upgrade procedure are the keyboard, mouse, monitor and power cord.

When powering on the computer, it's a good idea to power on the monitor first before the computer and let the monitor have five or ten seconds to warm up. That way you can see everything that is displayed on the monitor from the moment the computer is powered on.

Find a nice comfortable work space. I just use the middle of the floor.




Skip Ahead

  What You Need For A Hard Drive Upgrade - Home
  Screws, Antistatic Wrist Strap, Hard Drive Fitness Test
  Norton Ghost
  Norton Ghost Boot Disk Select Type
  Norton Ghost Boot Disk Create
  Norton Ghost Finish
  Old Hard Drive Partitions
  General Considerations About Upgrading The Hard Drive
  BIOS Changes
  Add The New Hard Drive - Jumper Pins
  Mounting Holes, Drive Cage
  Hard Drive Connectors
  Mounted In Drive Cage
  Installed Inside Computer
  Recognized In BIOS
  Hard Drive Fitness Test
  Copy Old Hard Drive To New Hard Drive
  Norton Ghost Source And Destination
  Norton Ghost Destination Drive Details
  Norton Ghost Progress And Finish
  Final Steps
  Site Map


© 2002-2011, Rob Williams, all rights reserved.
Building your own computer!  My Super PC - Click here when you're ready for the ultimate upgrade!  How to build an affordable, quality, fast PC!
My Tutorials
Computer Memory Upgrade
Hard Drive Upgrade
Video Card Upgrade
My Super PC


Even More Help
MySuperPC Forums


Great hardware stores
Crucial
Dealsonic
Newegg
PCMicroStore
TigerDirect


Great for software
Amazon


Deals and Rebates
Amazon Specials
Newegg Rebates
TigerDirect Bundles
ZipZoomFly Rebates


Web Hosting
Yahoo! Web Hosting


Utilities
Carbonite Backups
Mozy Backups
Norton AntiVirus, Tools
PC Tools


Laptops
HP Laptop Deals
Sony VAIO Wide Screen